IAI TB-02 - Direct Movement Operation; IO Test

6. Operation of ELECYLINDER
349
6.9.3 Direct Movement Operation
A position is specified directly to move the axis.
 Current position : Displays the current position.
 Target position : Touching “Target position” displays the numeric keypad. Enter a
desired target position and then touch [ENT].
 Vel. : Touching “Vel.” displays the numeric keypad. Enter a desired speed
and then touch [ENT].
 [Servo ON] : It shows the status of the servo whether it is ON or OFF for the axis.
When the servo is ON, display of ○ is activated and it is inactivated
when the servo is off.
 [Homing] : It shows the status of completion of the home-return operation.
When the home-return operation is incomplete, the display of ○ is
inactivated. Touch [Homing] and the axis starts home-return operation
and the display of ○ gets activated.
 [Move] : Touching [Move] moves the axis to the target position you have set.
 [Stop] : Touching [Stop] stops the axis.
6.9.4 I/O Test
The input signal and the output signal can be monitored.
You can also touch OUT00 to OUT02 to forcibly turn ON/OFF the corresponding output signals.