7. Gateway Parameter Setting Tool
378
7. Gateway Parameter Setting Tool
Gateway Parameter setting can be performed when this touch panel teaching pendant TB-02
is connected to a supported model.
Refer to “Applicable Models for Gateway Parameter Setting Tool” in this instruction manual for
the models to support.
Each window in the gateway parameter setting tool should differ depending on the type of
controller to be used, field network, structure of axes, operation mode and settings in each
parameter. Therefore, explanation in this section is prepared using some representative
windows.
7.1 Starting up Gateway Parameter Setting Tool
Gateway parameter setting tool should be started in the procedures described below.
IAI logo is displayed for approximately 1 second when the
power is turned on.
Version information is displayed.
Axis select window is displayed when several units are
connected.
[Gateway setting / Monitor] button is shown in the right bottom
of the screen for the supported models.
Touch [Gateway setting / Monitor].
When there are two or more gateway controllers in the same
network, the gateway select window opens.
Select the controller to be connected and touch [Next].
To Next Page
Loading...