IAI TB-02 - 6.8 Parameter Edit

6. Operation of ELECYLINDER
332
6.6.1 Monitor Screen
Touch [Production info] and the production information screen will be displayed. [Refer to 6.14]
Touch [Maint.] and the maintenance information screen will be displayed. [Refer to 6.6.2]
[Displayed Items]
 Input signals The status of each input signal is shown. ON is lit. OFF is unlit.
 Output signals The status of each output signal is shown. ON is lit. OFF is unlit.
 Cur. pos. The current position is shown.
 Cur. vel. The current speed is shown.
 Cycle time The cycle time calculated from the velocity and acceleration /
deceleration set for the way forth and the way back is shown.
 Cur. ratio The command value of electrical current is shown as a percentage of
the rated current.
 Overload level The overload level is shown in the rate that the motor raising
temperature assumed to generate the overload alarm set as 100%.
 PCB temp. Temperature of the control PC board in the actuator is shown.
 Alarm code The applicable alarm code is shown.
 Actuator S/N Shows the manufacturing number of the actuator.