3. Operation of CON Related Controllers
42
3.9 Monitor
The I/O statuses, current position and other information of the controller connected are
displayed.
Touch [Monitor] on the Menu 1 screen.
If the TP operation mode is not Monitor Mode 1 or 2, the following message screen appears.
Touch [Yes] to change to Monitor Mode 1 or 2.
If not, touch [No].
(Note) The safety speed does not change.
If the current mode is Teaching Mode 1, it changes
to Monitor Mode 1.
If the current mode is Teaching Mode 2, it changes
to Monitor Mode 2.
Touch [OK].
The main monitor screen appears.
The items and buttons to be shown will differ depending on the controller models.
The signal names to be shown will also differ depending on the controller models and operation
patterns.
To Next Page
Loading...