IAI TB-02 - 2. Connection; 2.1 Connecting with the Controller

2. Connection
24
Position controller/
ELECYLINDER cable
CB-TB1-C002
Minimum Bending Radius 48mm
Standard Cable (5m)
fixed on body unit
Minimum Bending Radius 36mm
Touch panel teaching
TB-02
2. Connection
2.1 Connecting with the Controller
Turn the controller power OFF before connecting or disconnecting the touch panel teaching
TB-02.
Caution:

Connecting or disconnecting the unit while the controller power is ON could
result in faults.

Confirm the connector engagement section and connect/disconnect while
taking care not to apply excessive force. If the connector does not fit in
smoothly, do not push it in with force. Failure to observe this could result in
faults.