IAI TB-02 - Changing Operating Axis

3. Operation of CON Related Controllers
32
3.4 Changing Operating Axis
If multiple controllers are connected to the communication line, the axis selection screen
appears.
Also, it opens by touching [Change operation axis] in the Menu 2 screen or [Axis Select] in the
Gateway Menu screen.
If only one controller is connected, you need not select an axis.
Select the axis to be operated in the touch panel teaching
pendant and touch it.
Connection with the selected controller axis starts.
The following screen is shown when the enable feature
parameter of the controller is valid in TB-02.
Select either [Yes] (Inactivate Enable Feature) or [No]
(Activate Enable Feature).
The following screen is shown when the enable feature
parameter of the controller is invalid in TB-02D.
Select either [Yes] (Activate Enable Feature) or [No]
(Inactivate Enable Feature).
When connection with the controller is established, the Menu
1 screen appears.