8
Handling Precautions
In this touch panel teaching, the language to be displayed can be changed.
Refer to the following for how to change it.
CON related controllers 3.1 Displayed Language Change
SEP related controllers 4.1 Displayed Language Change
MEC related controllers 5.1 Displayed Language Change
ELECYLINDER 6.1 Displayed Language Change
Do not apply mechanical shocks on this touch panel teaching pendant TB-02, because they
may cause failure.
When operating this touch panel teaching pendant TB-02, be sure to hold the teaching pendant
to prevent the cables from receiving unnecessary tensile loads.
If using the liquid crystal display screen for a long time, the brightness decreases. In order to
extend the life of LCD, set the time setting to turn off in the environment setting to turn it off
automatically, and disconnect from the controller when it is not in use.
Do not touch more than one point at the same time, because the touch panel is an analog
resistive film system. If you touch more than one point, the center position of more than one
point may react and operate.
Operate the touch panel by 0.5 N force or less.
There is a risk that the panel will be broken if it is operated by stronger force than that.
The life of the touch panel is around one million times under the condition of depression at the
same point. (Based on the usage environment of 25 degrees C)
Turn off the power to the controller before putting it in or out. Putting it in and out while the
power is on may cause malfunction.
When putting it in, check the connector matching position and insert it carefully with no excess
force applied to any unexpected direction. Do not attempt to insert it forcefully when it does not
go in smoothly.
For a Secure Digital memory card, choose a SD/SDHC memory card with 1G to 32G.
(Toshiba-made recommended) Also, use FAT32 Format for the file system.
Operation of the JOG switch on the front panel of RCON drive unit should be invalid in the
conditions below.
(1) When Parameter No. 194 JOG Switch is set to “1: Invalid”
(2) In AUTO Mode or when TP Operation Mode is set to Monitor Mode in manual setting
(MANU)
(3) When either of the position edit window, simple programming window, JOG/inching window,
position move window or number indicating move window is open
Also, if TB-02 gets disconnected from the controller in the condition that either of windows
stated in (3) is open, JOG switch operation will get disabled.
Caution : This touch panel teaching pendant TB-02 is exclusively designed for use with IAI
controllers. Never connect it to other equipment.
Failure ma
occur.
To Next Page
Loading...