5. Operation of MEC Related Controllers
299
5.11 Maintenance – Parameters
Set the parameters and axis number. You can change the system password and reset all
parameters to their factory defaults.
Touch on the MEC menu screen.
Touch [Parameter].
Touch [Menu] to return to the MEC menu screen.
The password entry screen appears if the system password is other than “0000.”
Enter the password and then touch [ENT].
The default system password is “5119”.
For how to change the system password, refer to
5.11, “Maintenance – Parameters [Change System
Password].”
A desired password can be set using the “system
password” parameter accessible from the
maintenance menu.
Select and touch [Edit Parameter], [Init Parameter] or
[System Password].
Change ax.
To Next Page
Loading...