3. Operation of CON Related Controllers
37
3.7 I/O Control Guide
Here, explains with actual operation how to perform positioning operation by I/O control when
PIO Pattern is set to 0 in two-way communication style.
Perform operation in order of [Introduction] → [Servo ON] → [Release of pause] → [Homing]
→ [Expl. for pos.] → [Positioning] → [End].
Touch [I/O control guide] icon.
This window appears when PIO Pattern Select is
set to a number except for “0”.
Confirm that there would be no problem if a
change is made to the parameter, set PIO
Pattern Select to “0”, and then select this guide
menu.
Follow the following descriptions to perform operation.
Touch [←] button to return to the previous screen.
There may be some procedures to skip depending on the condition of the actuator.
Also, for those terms marked with “ ”, explanation can be checked by touching [Glossary] on the right
bottom of the screen.
Introduction
To Next Page
Loading...