IAI TB-02 - Axis Name Edit

6. Operation of ELECYLINDER
357
6.14.1 Axis Name Edit
A name can be set on an axis. To show the axis name, select Axis Name at the axis name
display section in the environment setting screen. [Refer to 6.15 Environment Setting [Axis Name
Display]]
Axis name is shown in the right top of each screen or select axis screen.
Even if the axis name is set to be shown, axis number will be shown if there is no axis name
setting conducted.
(Note) The available characters for setting in TB-02 are capitalized font English characters (from
A to Z) and numbers (from 0 to 9).
[Axis Name Edit Operation]
Touch [Env. set.] on the Menu 2 screen.
Set to “Axis Name” for the axis name display.
Touch [Write the above setting].
(Note) If writing is not conducted, the setting will go back to
those before making a change when moving to
another screen.
Touch [Information] on the Menu 1 screen.
Axis Name Display
Axis Name Display