5. Operation of MEC Related Controllers
296
The operating direction is shown by using an example of stopping at 2 points.
The current position of the axis is shown.
The speed of the axis is shown.
Instruction Vel: Select [10%], [50%] or [100%] as the speed for trial operation. If the
speed set on the position setting screen is 600 mm/s, for example, the
trial Operation speed will become 600 mm/s if [100%] is selected, 300
mm/s if [50%] is selected, or 60 mm/s if [10%] is selected.
Forward: Touching [Forward] causes the actuator to move toward the end point.
Backward: Touching [Backward] causes the actuator to move toward the start
point.
Continuous: Touching [Continuous] causes the actuator to move continuously until
[Stop] is touched.
If the actuator is set to stop at 2 points, it will move between the start
point and end point repeatedly.
If the actuator is set to stop at 3 points, it will move in the sequence of
intermediate point end point start point repeatedly.
Stop: Touching [Stop] causes the actuator to stop.
Opp, Normal: Touching [Opp] or [Normal] toggles the display mode between normal
and reversed-home.
To Next Page
Loading...