6. Operation of ELECYLINDER
361
[Change Pos Edit Password]
Change the position edit password.
Touch [Position edit password change].
If the system password is not “0000”, the password entry screen appears.
Input a system password.
Touch [ENT].
Enter the new position edit password to change to.
If the position edit password is not set, enter “0000”.
Touch [ENT].
Touch [Change].
The new password after change will be displayed. Make
sure it shows the same as the password you have set.
Touch [OK].
The default system password is “5119”.
For how to change the system password, refer to
[Change System Password] as described later.
To Next Page
Loading...