KAESER SIGMA CONTROL 2 User Manual

12. Press the «Enter» key.
The setting is applied.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
6 Compressor clock
Menu
·········
01 Mon-Fri 06:30AM on
Switching point 01 is set
02 Mon-Fri 12:00PM off
Switching point 02 is set
03 Mon-Fri 01:00PM on
Switching point 03 is set
04 Mon-Thu 05:00PM off
Switching point 04 is set
05 Fri 03:00PM off
Switching point 05 is set
13. Press the «Right» arrow.
14. Press «Enter».
The on/off indicator flashes.
15. Use «Up» or «Down» to set the Compressor On action.
16. Press «Enter».
The setting is applied.
The Compressor ON action is set for the first switching point.
17. Specify further switching points in the same manner.
Result Weekdays, time and the Compressor ON/Compressor OFF actions are set for all switching points
of the user-defined clock program.
8.5.1.3 Activating the «Timer control» key
1. Use «Up» or «Down» to select the Key clock line.
2. Press «Enter».
The check box Key clock flashes in the active line.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
6 Compressor clock
Menu
Key clock : ☑
Active line with activated check box
Reset : ☐
01 Mon-Fri 06:30AM on
Switching point 01:
02 Mon-Fri 12:00PM off
Switching point 02
03 Mon-Fri 01:00PM on
Switching point 03
3. Press the «Up» key.
The check box is activated.
4. Press «Enter».
The setting is applied.
5. Press «Escape» repeatedly to return to the main menu.
Result The «Time control» key is activated.
8 Initial Start-up
8.5 Configuring machine start and stop
94
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet