KAESER SIGMA CONTROL 2 User Manual

4. Use the «Up» or «Down» keys to select the Reset line.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.2.3.1 pA/pB Clock
Menu
Reset : ☐
Active line
·········
01 Mon-Fri 06:30AM pA
02 Mon-Fri 12:00PM pB
03 Mon-Fri 01:00PM pA
04 Mon-Thu 05:00PM pB
5. Press the «Enter» key.
The check box Reset: will flash.
6. Press the «UP» key.
The check box is activated.
7. Press the «Enter» key.
The timing program is now deleted.
Setting the switching point
Precondition Password access level 2 is activated.
1. Open the 5.2.3.1 <Configuration – Pressure control – Load control – pA/pB Clock> menu.
The Timing program menu is displayed.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.2.3.1 pA/pB Clock
Menu
Reset : ☐
·········
01 n.a. 00:00AM pA
02 n.a. 00:00AM pA
03 n.a. 00:00AM pA
04 n.a. 00:00AM pA
2. Press the «Enter» key.
The display for the set operating mode flashes.
8 8 p s i 0 8 : 1 5 A M 1 7 6 ° F
Header
5.2.3.1 pA/pB Clock
Menu
Reset : ☐
·········
01 Mon-Fri 06:30AM pA
Setting for weekdays, time, pA
02 Mon-Fri 12:00PM pB
Setting for weekdays, time, pB
03 Mon-Fri 01:00PM pA
04 Mon-Thu 05:00PM pB
3. Use «Up» or «Down» to set the weekdays.
8 Initial Start-up
8.9 Setting the machine for local mode
116
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.1.2 No.: 9_9450 13 USE

KAESER SIGMA CONTROL 2 Specifications

General

Controller Type	Microprocessor-based
Model	SIGMA CONTROL 2
Manufacturer	KAESER
Input Voltage	24 V DC
Protection Class	IP54
Communication Protocols	Modbus, Profibus
Data Logging	Comprehensive data logging
Remote Monitoring	Yes
Communication Interface	Ethernet