Keysight Technologies C Series - Page 257

Keysight N9915-90020 User’s Guide 257
RTSA (Real-time Spectrum Analyzer) Mode—Option 350
In this Chapter:
See Also
“Frequency Range” on page 259
“Scale and Units” on page 261
“External Gain” on page 261
“Attenuation Control” on page 262
“Preamplifier Control (Opt 235)” on page 263
“Check for Compressed Measurements” on page 263
“Spectrum Selection” on page 264
“Setting the IF Path” on page 268
“Resolution Bandwidth (Res BW)” on page 268
“Triggering” on page 269
“Single / Continuous / Restart / Time Per Div” on page 272
“Baseband (N99xxC-Series FieldFox Models Only with Option 350 RTSA or
Option 233 SA–Mixed Models)” on page 273
“Points (not user settable)” on page 275
“Trace Display States (RTSA)” on page 275
“Average Count, Show Density, Blue, and Red Percentage Limits” on
page 277
“Average Count” on page 278
“Alignments” on page 278
“Detection Method” on page 276
“Display Line” on page 278
“Limit Lines” on page 279
“Audio Beep at Marker Power” on page 280
“Spectrogram Display (RTSA Option)” on page 281
“Record/Playback (RTSA Option)” on page 283
Optional Settings:
“All about Markers” on page 734
“All about Limit Lines” on page 749