288 Keysight N9915-90020 User’s Guide
RTSA (Real-time Spectrum Analyzer) Mode—Option 350
Record/Playback (RTSA Option)
the rotary knob. Active when playback is paused. Learn more in
About State and User Tags in
“About State and User Tags” on
page 285.
— Playback Trace Activated automatically when Paused. Allows you to
continue playback from a specific trace, or scroll through traces
manually. Enter a value between 1 and the total number of traces
using the numeric keypad, arrows, or the rotary knob.
—
Stop Immediately stops playback. Then choose from the following:
— Play Start playback from trace 1.
—
Record Resume recording from the last recorded trace.
—
Record Playback Setup
Return to the setup menu to change
Configuration settings or Close the session.
Recording Configuration
To change Recording Configuration settings:
1. Press Trace 6 > Record Playback
2. Press New Session or Recall an existing session.
3. Press
Recording Configuration
4. Then choose from the following:
— Record Time Sets the amount of time to record traces. Default is
MAX, which is to record indefinitely. Enter a value between 1s and 1
Ms (million) seconds using the numeric keypad, arrows, or the
rotary knob. When set, a timer appears during recording in the
lower-left corner which counts DOWN from the specified time.
—
Record Source Determines which trace is recorded. Sets where, in
the FieldFox data flow, data is recorded. Learn more in
“Record
Source” on page 289
. Choose from the following:
— First Active Trace (Default) This setting automatically
selects the first active trace (1,2, 3 or 4) (i.e., any state
other than View or Blank).
—
Trace 1,2,3,4 Records data from the corresponding trace
in its current state.
—
Record Interval Sets the amount of time to wait between individual
trace recordings. Default is MIN, which is to wait 0 seconds (record
traces as fast as possible). Enter a value in seconds between 0 (no
delay) and 10,000 seconds - about 3 hrs) using the numeric keypad,
arrows, or the rotary knob.
To Next Page
Loading...
