Keysight Technologies C Series - How to Playback a Session

Keysight N9915-90020 User’s Guide 287
RTSA (Real-time Spectrum Analyzer) Mode—Option 350
Record/Playback (RTSA Option)
— Recall Session then Open and select a session.
3. Press
Recorder Player
4. Press Record
REC is displayed in the left of screen graticules.
During recording, choose from the following:
—
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
— Stop Immediately stops recording. Then choose from the following:
—Press Play to start replaying the recording from the beginning.
—Press
Record to continue recording.
—
User Tag Press to insert a User Tag at the current recorded trace. This
allows you to quickly move to this location during playback. Learn more in
About State and User Tags in
“About State and User Tags” on page 285.
How to Playback a Session
1. Press Trace 6
2. If the session is already open, skip the following step. Otherwise:
3. Press
Record Playback Setup
— Press Recall Session Then select a session to playback and press
Open.
4. Press Recorder Player
5. Press Play
PLAY is displayed in the left of screen graticules during playback. When the
end of the recording is reached, playback begins again at trace 1 and
continues to loop indefinitely.
During playback, choose from the following:
—
Pause Resume Temporarily halts playback. Then choose from the following:
— Pause Resume Press to continue playing.
—
Playback State/Tag Allows you to continue playback from a state
tag, or scroll through the state tags. Enter a value between 1 and the
total number of state tags using the numeric keypad, arrows, or
If these are large recordings on a device, it could take several seconds for
the FieldFox to display the list.