Keysight Technologies C Series - FieldFox Package Installer

810 Keysight N9915-90020 User’s Guide
System SettingsFUTURE
System Configuration
FieldFox Package Installer
The FieldFox Package Installer enables you to download new versions of
firmware from either a USB memory or SD Card. Additionally, the Utility softkey
enables you to backup user files or restore user files.
How to run the Installer
1. Press System 7 > System Configuration > More > Firmware Update >
Start Installer.
The Installer software opens after a couple of seconds.
2. Then chose from the following:
— Then the arrows or the knob to scroll to the firmware you want to
install.
3. Press
Start Install and the following occur:
“Current Step Progress:” bar and a “Total Progress:” bar are
displayed along with this message: “Copying package. Do not
remove install media.”
When the installation is completed, the FieldFox reboots.
How to backup files
This procedure backs up your user data to a USB or SD card. See also
“How to
restore files” on page 808
.
From the initial Installer menu:
1. Press Utility
> Backup Data
A message is displayed: “Choose backup file location.”
2. Then choose either SD Card or USB
A progress bar and a message is displayed: “Saving user data…”
Before running the Installer to update your firmware, you might want to
back up your user data. Refer to
“How to restore files” on page 808.
If no files are displayed, verify that a USB memory or SD Card is installed
and press
Refresh List.
If you backup multiple versions of the user files, the FieldFox appends a
“_#” to each subsequently stored file. During restore, the file with the
highest appended number is loaded into the FieldFox.