Keysight Technologies C Series - How to Play a Data Log

410 Keysight N9915-90020 User’s Guide
Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5G TF
Option 377, 5G NR / 5G NR EVM Conducted Option 378
How to Use Data Logging (OTA Options 370, 372, 377, and 378)
— Then Recall Log File.
—
Auto Save (default = OFF)
— Then
Back
c. Optional: Press Indoor Map Data Logging then
— Record Indoor Data or Recall Indoor Log File. Learn more,
refer to
Chapter 16 Mapping and “Option 352 Indoor Maps
Setup Procedure” on page 491
.
— Then choose
Navigate OFF ON, Data Selection, Zoom, Pan,
Record Data, More
Learn more, refer to Chapter 16 Mapping and “Setting up Data Logging” on
page 503
. See also, Chapter 33, “File Management.”
How to Play a Data Log
—Press Trace 6
— If the session is already open, skip the following step. Otherwise:
—Then
More > Data Logging > Playback
—Then Recall Log File and select a file
——Then Recall File
—Then Play to playback your Table data.
is displayed in the left of screen graticules during playback. When the
end of the recording is reached, playback begins again at trace 1 and
continues to loop indefinitely.
During playback, choose from the following:
—
Pause Resume
Temporarily halts playback. Then choose from the following:
— Pause Resume
Press to continue playing.
—
Stop
Immediately stops playback. Then choose from the following:
— Play Start playback from trace 1.
—
Recall Log File
Opens a list of stored data files.
Select a file to playback.
— Recall File
If these are large recordings on a device, it could take several seconds for
the FieldFox to display the list.