Keysight Technologies C Series - To change Data Logging Configuration settings:; How to Play a Data Log

Keysight N9915-90020 User’s Guide 517
Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Use Data Logging (Option 352)
is displayed in the left of screen graticules.
During recording, choose from the following:
—
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
— Stop Immediately stops recording. Then choose from the following:
—Then Record Save/Recall To save a log file, recall a log file, or
change your file settings. Learn more, refer to
“To change Data
Logging Configuration settings:” on page 517
.
——Press Save Log File to save the current Table data (i.e., default
save device is Internal).
—Then
Record Settings (Outdoor Mapping only) To change your
measurement interval settings. Learn more, refer to
“To change Data
Logging Configuration settings:” on page 517
.
To change Data Logging Configuration settings:
—Press Trace 6
—Then Data Logging then choose:
—Then
Record Settings (Outdoor Mapping only)
—Optional: Then Meas Interval > ON
——Then
Interval Type > choose Time or Distance.
——Then, if applicable
Time Interval enter time interval in seconds.
Or
——Then, if applicable
Distance Interval enter distance interval in
miters.
—Then Record Save/Recall
—Then Device
(Internal (default), SD Card, or USB)
—Then
File Type (CSV (default), DREC (Option 360 Only), or KML)
Learn more, refer to the
Chapter 33, “File Management”.
How to Play a Data Log
—Press Trace 6
— If the session is already open, skip the following step. Otherwise: