Keysight N9915-90020 User’s Guide 809
System SettingsFUTURE
System Configuration
— Static IP Address - Enter the IP Address – including periods - in the format
nnn.nnn.nnn.nnn
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
format nnn.nnn.nnn.nnn
— Static Gateway - Enter the Static Gateway – including periods - in the
format nnn.nnn.nnn.nnn
— Static DNS - Enter the Static DNS – including periods - in the format
nnn.nnn.nnn.nnn
— Apply Settings Choose from:
— Power Up The above settings take effect when the FieldFox is
started.
— Now The above settings take effect immediately.
3. Press Done Edit when finished.
Power ON
When the FieldFox is without a power source, this setting allows the FieldFox
to power ON when the DC Adapter is inserted without pressing the power
button.
How to set Power ON
1. Press System 7
> System Configuration > More > Power ON
2. Then choose from the following:
— Auto The FieldFox will power ON when the DC Adapter is inserted.
—
Manual The FieldFox will power ON only when the power button is
pressed.
For all FieldFoxes with firmware ≤A.08.18 and ≤A.09.50 FW, when using
Static IP addresses:
– Either a valid Static Gateway is required or 0.0.0.0.
– Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
To Next Page
Loading...
