768 Keysight N9915-90020 User’s Guide
System SettingsFUTURE
User Preset
— Mode Preset Returns only the current Mode to the factory default
settings. The current settings for all other Modes remain.
User Preset
User Preset allows you to store custom settings for each mode, then recall the
settings when the Preset key is pressed. Your custom settings are saved to a
standard State file (UserPreset.sta). However, unlike State files, calibration
data is NOT saved. Learn more about State files in “Set File Type and Select
Device” on page 823
.
How to set User Preset
1. Make your custom settings for all modes.
2. When finished, press Preset
.
3. Then
Save User Preset, then select Yes to confirm.
4. Then
User Preset ON
How to recall User Preset
—Press Preset.
— Then choose from the following:
—
Preset (User) The entire UserPreset.sta file is recalled. ALL modes
assume the settings that were in place when the User Preset was
saved. The active mode is the mode that was visible when the file was
saved.
— Mode Preset (User) The settings for only the current mode are
recalled from UserPreset.sta.
— Only the instrument settings are saved to UserPreset.sta. No trace data
or calibration data is saved.
— User Preset ON / OFF is saved as a Preference setting. Like all
preferences, this setting survives a FieldFox shut down and power ON.
Therefore, when User Preset is ON during shut down, the FieldFox will
load UserPreset.sta when it is powered ON.
— To return to Factory Preset, select
User Preset OFF. The contents of
UserPreset.sta remain stored on the FieldFox. When User Preset is OFF,
you can also set the Startup Mode preference that determines which
mode will be visible after powering ON. Learn more in
“Startup Mode”
on page 784
.
.
To Next Page
Loading...
