Keysight N9915-90020 User’s Guide 457
5G Rapid Prototype Phased Array Antenna – Option 360
How to Use Data Logging/Playback (Option 360)
How to Record a Data Log
—Press Trace 6
—Then Data Logging
—Then Record
is displayed in the left of screen graticules.
During recording, choose from the following:
—
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
— Stop Immediately stops recording. Then choose from the following:
—Then Record Save/Recall To save a log file, recall log file, or change
your file settings. Learn more, refer to
“To change Data Logging
Configuration settings:” on page 456
.
——Press Save Log File to save the current Table data (i.e., default
save device is Internal).
—Then
Record Settings (Outdoor Logging) To change your
measurement interval settings. Learn more, refer to
“To change Data
Logging Configuration settings:” on page 456.
To change Data Logging Configuration settings:
—Press Trace 6
—Then Data Logging then choose:
—Then
Record Settings (Outdoor Mapping Only)
—Optional: Then Meas Interval
> ON
——Then Interval Type
> choose Time or Distance.
——Then, if applicable
Time Interval enter time interval in seconds.
Or
——Then, if applicable
Distance Interval enter distance interval in
miters.
Data Log-Play files are saved to:
— If File Folder is set to Default then Data Log-Play files are save-recalled
to: "[CurrentDevice]\RecordPlayback\PAA"
— If File Folders are set to System, then Data Log-Play files are
save-recalled to: "CurrentDevice\<UserSelectedFolder>\
To Next Page
Loading...
