Keysight N9915-90020 User’s Guide 811
System SettingsFUTURE
Service Diagnostics
3. Press Cancel to exit without backing up your files and returning to the
initial Installer menu.
How to restore files
This procedure restores user files from a USB or SD card. See also
“How to backup
files” on page 807
.
If your stored any user files to a USB or SD card, this procedure restores those
files.
From the initial Installer menu:
—Press Utility
—Then Cancel to exit without restoring your files and returning to the initial
Installer menu.
Or
Press
Restore Data
— A message is displayed: “This option will COMPLETELY ERASE
existing user data. ARE YOU SURE?”
—Then No to return to the previous menu without restoring files.
Or
Press
Yes
— Then choose either SD Card or USB
A progress bar and a message is displayed: “Restoring user data…”
Service Diagnostics
Restoring files overwrites the existing user data on the FieldFox.
If you backup multiple versions of the user files, the FieldFox appends a
“_#” to each subsequently stored file. During restore, the file with the
highest appended number is loaded into the FieldFox
When the FieldFox is powering up, the firmware does a very high level verification of the
hardware components. This high level verification does not involve applying any power to any of
the internal hardware components. The FieldFox will generate an error message, if the hardware
fails the verification. To learn more, refer to the FieldFox Programming Help and to the Service
Guide for your FieldFox.
To Next Page
Loading...
