Keysight Technologies C Series - Playback Configuration; Manage Sessions

290 Keysight N9915-90020 User’s Guide
RTSA (Real-time Spectrum Analyzer) Mode—Option 350
Record/Playback (RTSA Option)
Playback Configuration
By default, trace sweeps are played back as fast as the trace can be drawn on
the screen. The following setting allows you to slow playback. In addition, you
can manually scroll through individual traces using Playback Trace, or scroll
through State and User Tags using Playback State/Tag. Learn more in How to
Playback a Session in
“How to Playback a Session” on page 287.
To slow playback of a session:
1. Record a new session or Open an existing session.
2. Press
Playback Configuration
3. Press Playback Interval
4. Enter a value in seconds between 0 (no delay) and 100 using the numeric
keypad, arrows, or the rotary knob. After using the keypad, select a
multiplier key. Learn about multiplier abbreviations.
5. Press
Enter
Manage Sessions
1. Press Trace 6 > Record Playback
2. Press Record Playback Setup The following selections are available ONLY
when a session is NOT open.
3. Press Storage Device
to select the media which stores the sessions to be
managed. This is a different setting from the Save/Recall Storage Device
setting.
4. Choose from the following:
—
Internal FieldFox memory (default)
—
SD Card An external SD Card (must be inserted)
— USB An external USB flash drive (must be inserted)
5. Press Manage Sessions
6. Choose from the following:
— Rename Using the FieldFox labeler, change the name of the session.
AutoSession (n) is the default name where (n) is the next-available
number. Learn more in
“How to use the FieldFox labeler ” on
page 820
.
If these are large recordings on a device, it could take several seconds for
the FieldFox to display the list.