Keysight Technologies C Series - Startup Option; Display

Keysight N9915-90020 User’s Guide 785
System SettingsFUTURE
Preferences
Startup Option
The Startup Option setting determines the behavior of the FieldFox after a
restart.
— If the Startup Option is set to Last Power Off State the mode that the
FieldFox was set to before a reboot is displayed on power up.
— When the Startup Option is set to User (See Startup Mode), (Default) the
Startup Mode selected is the first mode visible on startup and is Option
dependent. If User Preset is set to ON, it is loaded on power up.
See
“User Preset” on page 768.
How to setup Startup Option
1. Press System 7
> Preferences > Preferences
2. Then scroll to Global Settings > Startup Option and press Edit.
3. Then repeatedly press the
Startup Option to toggle through the available
choices.
—
User (See Startup Mode) or
—
Last Power Off State
Display
Choose the Display values (Display Colors, Trace Width, Brightness, Title
Enabled, Title). See
“Display (Settings)” on page 769.
How to select Display values:
1. Press System 7
> Preferences > Preferences
2. Then use arrow softkeys () or the knob to select Display
3. Then
Edit for each of the following:
— Display Colors
— Indoor (default)
An instrument can never power up for the first time in LAST.
If line power to the instrument is interrupted, by any of the following, Last
Power Off State may not work properly:
– If there is no battery and the line cord plug is removed
– If the test rack/bench power is switched off power.
For proper operation,
Last Power Off State depends on your shutting
down the instrument via softkeys Mode > More. . . (Varies with number of
Options loaded) > “Shut down” | “Restart”.