Keysight Technologies C Series - 12 Electromagnetic Interference (EMI) Measurements - Option 361

323
Keysight Handheld Analyzers
N99xxC User’s Guide
12 Electromagnetic Interference (EMI) Measurements –
Option 361
Requirements
— EMI mode measures signals at the SA RF Input Port 2 connector.
— EMI mode requires the FieldFox to have SA mode (Option 233 on
combination analyzers) installed.
Recommended, but not required:
—EMI chamber.
— Preamplifier (Option 235) to improve receiver sensitivity.
—Filters
— Line impedance stabilization network (LISN) – conducted emissions testing
— Transient limiter – conducted emissions testing
— Calibrated antenna – radiated emissions testing
— Signal generator (e.g., EXG, MXG)
— Set of antennas
— Set of near field probes (e.g., Keysight N9311X Series of antennas and field
probes.)
EMI Option 361 measures radiated and conducted emissions. With EMI you
can measure the unintentional generation, propagation, and reception of
electromagnetic energy that might cause your device to violate
pre-compliance/compliance testing. This includes the emissions and immunity
(susceptibility) levels of electromagnetic energy.