Keysight Technologies C Series - CAT;NA; SA

792 Keysight N9915-90020 User’s Guide
System SettingsFUTURE
Preferences
— Distance Units:
— Meters (default)
— Feet
— Inches
— TDR Sweep:
— Cable (default and the most accurate)
— Auto
3. Then
Done Edit (after each change in setting)
CAT/NA
Choose the CAT/NA settings for SnP file save, default factory error corrections,
extended cal default. See also
“> What Data Processing functions are
included in saved SNP Data:” on page 826.
How to select CAT/NA defaults:
1. Press System 7 > Preferences > Preferences
2. Then use arrow softkeys or the knob to select CAT/NA
3. Then Edit for each of the following:
— SnP File Save
— Default
— Advanced
— Default Factory Error Corr. (N995xB/6xB Only)
— Enhanced Response
— Full 2 Port
— Extended Cal Default (N995xB/6xB Only)
— On
— Off (default on models >6 GHz)
4. Then
Done Edit
(after each change in setting)
SA
Choose the SA setting for Individual measurement Control default. See also
“Alignments” on page 206.
How to select SA defaults: