Keysight Technologies C Series - 17 Direction Finding (Option 390 Time Difference of Arrival (TDoA)) - Requires Spectrum Analyzer Mode (Option 233), and GPS Receiver (Option 307)

525
Keysight Handheld Analyzers
N99xxC User’s Guide
17 Direction Finding (Option 390 Time Difference of Arrival
(TDoA)) – Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307)
S9910A Keysight Signal Measurement Software (KSMS) is a PC-based
software which enables you to use the FieldFox as a receiver in direction
finding measurements. Refer to
https://www.keysight.com/find/assist/.
The following Option(s) are available for use with KSMS:
— Option 390 TDoA used to geo–locate signals that were measured using the
SA RF Input Port 2 connector.
The FieldFox requires Option 390 for TDoA direction finding and GPS (Option
307) installed.
To install the Pathwave Keysight Signal Management Software (KSMS) on your
PC, refer to
https://www.keysight.com/us/en/products/software/pathwave-test-softwar
e/pathwave-measurements.html
.
For help using the Pathwave Keysight Signal Management Software (KSMS),
refer to the KSMS web help
https://www.keysight.com/us/en/products/software/pathwave-test-softwar
e/pathwave-measurements.html
.
IMPORTANT!
B model FieldFox units require S9910A Pathwave Keysight Signal
Measurement Software KSMS software to use the TDoA Option 390. Learn
more, refer to
https://www.keysight.com/us/en/products/software/pathwave-test-soft
ware/pathwave-measurements.html
.