63
Keysight Handheld Analyzers
N99xxC User’s Guide
4 DTF (Distance to Fault) Measurements
CAT Mode Distance to Fault (DTF) measurements are generally used to locate
problems, or faults, in a length of cable or transmission line. In this chapter, the
cable to be tested is referred to as the DUT (Device Under Test).
Settings that are NOT unique to DTF measurements are documented in the
CAT Mode
Chapter 3, “CAT (Cable and Antenna Test) Mode.”
In this Chapter
“How to make DTF Measurements” on page 64
“DTF Settings Table” on page 66
“DTF Measurement (Format)” on page 66
“DTF Start and Stop Distance” on page 67
“Frequency Mode” on page 67
To Next Page
Loading...
