Keysight Technologies C Series - Page 499

Keysight N9915-90020 User’s Guide 497
Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Figure 16-16 Example of England Displayed Text
e. Else, to import a *zip file (i.e., you can come back and do this later
after the mapping route is defined).
i. Press System 7
> Utilities > Mapping
ii. Then to import map pictures, press
Map Explorer (Get Maps)
>
Import Maps
iii. Press Import Maps (ZIP) > Recall File and change latitude and
longitude values to view site maps from pictures (KML).
3. If not done, connect your equipment similar to
Chapter 14, “5G Rapid
Prototype Phased Array Antenna – Option 360”, Chapter 15, “USB
Antennas – (Full Capability Requires EMF Option 358, and either SA mode
(Option 233 Mixed Analyzers) or OTA—5G NR / 5G NR EVM Conducted
Option 378)”, and to Figure 14-1 on page 425
See also,
— For setting up GPS Option 307, refer to Chapter 31, “System
Settings,” and then “GNSS (GPS+) and GPS” on page 795.
— For setting up a phased array antenna, refer to
Chapter 14, “5G
Rapid Prototype Phased Array Antenna – Option 360.”
Import ZIP file using FieldFox Map Support Tool with Import Maps (ZIP)