Keysight Technologies C Series - Page 510

508 Keysight N9915-90020 User’s Guide
Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
To enable the Record Data softkey, move the cursor using
the arrow hardkeys or the RPG to highlight the Location:
Value cell in the table. Begin walking with an antenna and
press Record Data as required to map a location.
—
More Opens a menu of softkeys to Undo, set Labels &
Icons, RPG actions, Save Image, and Back.
Labels & Icons
Opens a softkey menu where you can
enable/disable and select map icons:
——
Labels OFF ON -
Enables/Disables map data
point labels. When enabled, a
label is displayed for every map
data point (e.g., “Data 1”). When
disabled, labels are not
displayed for the map data
points.
——
Icons Flag Point Line - Sets
the type of icon that is used to
display a map’s data points.
——Pointer OFF ON-
Enables/disables the bore sight
pointer.
Undo
To undo last indoor map setting change
RPG [Zoom]
Opens a menu to set the RPG’s functionality for
mapping. Choose from:
——
Zoom - (default) Zooms in/out.
——<––> - RPG knob moves the
map East or West.
——^|v - RPG knob moves the map
north or south.