Keysight N9915-90020 User’s Guide 579
Power Meter (USB/LAN) Mode - Option 302
Troubleshooting
b. The PWR LED will turn off when the Sensor is ready to be
reconnected. The other LED next to it should be off as well.
c. Then press, Meas Setup 4 > More > LAN Sensor Settings >
Reconnect.
The LEDs may turn on and off during the reconnection, and the sensor may report “Zeroing” or
“Attempting to connect” messages. This reconnection attempt could take up to a minute or so.
The data acquisition will resume once the connection is re-established.
To Next Page
Loading...
