Keysight N9915-90020 User’s Guide 593
Pulse Measurements Mode – Option 330
Supported Power Sensors
Supported Power Sensors
Pulse measurements are made using any of the Keysight the following X-Series
USB and LAN Peak Power Sensors.
Zeroing of the compatible X-Series USB and LAN Peak Power Sensors is
performed automatically at power up, every 5 seconds, and prior to measuring
low level signals.
Switching between Pulse Measurement Mode and Power Meter Mode
NOT Supported - Using a single USB or LAN Peak Power Sensor and
switching between Power Meter Mode and Pulse Measurement Mode. Both
modes will attempt to program the sensor, which could cause one or both
modes to hang, or at least report inaccurate data.
Supported - Using one X-Series Average Power Sensor connected to the
top USB port for Power Meter Mode, and one X-Series Peak Power Sensor
connected to the bottom USB port for Pulse Measurement Mode.
USB and LAN Power Sensors
a
— “Best Practices For Making The Most Accurate Radar Pulse Measurements”
https://www.keysight.com/us/en/assets/7018-03483/application-notes/5991
-0434.pdf
a. Learn more, refer to the User’s Guide and Programming Guide for your USB or LAN
model power sensor.
Table 24-1 Pulse Measurement X-Series USB and LAN Power Sensors
USB Power Sensor Model Numbers
LAN Power Sensor Model Numbers
a
U2021XA L2061XA
U2022XA L2062XA
U2042XA U2063XA
U2044XA L2064XA
U2049XA L2065XA
U2062XA L2065XT
U2063XA
U2065XA
a. LAN power sensors require FieldFoxes to have CPU2 installed.
To Next Page
Loading...
