Keysight Technologies C Series - Page 651

Keysight N9915-90020 User’s Guide 649
Channel Scanner (Option 312)
How to Set Up Channel Scanner
— Record Indoor Data or Recall Indoor Log File. Learn more,
refer to
Chapter 16 Mapping and “Option 352 Indoor Maps
Setup Procedure” on page 491 ans “Setting up Data Logging”
on page 503
.
d. Optional: Press
Signal Locate – Opens a softkey menu of directional
finding (DF) bearing softkeys. Learn more, refer to Chapter 16
Mapping and
“How to Add Directional Finding (DF) Bearing” on
page 513
.
5. Press Back to return to previous menu.
6. Outdoor Mapping only: If recording, then:
—
View Map OFF ON To enable/disable the current map view (default
= latitude/longitude = 0.00/00. Need GPS to view current location
(default = OFF).
—
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue
recording.
—
Stop Immediately stops recording and a “Save the Log File” menu
opens to rename and save your data log file.
— (Press Record to begin a new recording.)
— Then
Maps To enable map view and related features (e.g., Data
Selection, Red/Blue Limits, Labels & Icons, Zoom).
—
Data Selection
Opens a softkey menu to set the active
data channel, sort type, and sort order.
Learn more, refer to Chapter 16 Mapping and “Setting up
Data Logging” on page 503. See also, Chapter 33, “File
Management.”
— Red/Blue Limits
Opens a softkey menu to assign power
values to the red (high power limits) and blue (low power
limits) heat map display limits (defaults: Red Limit =
–20 dBm, Blue limit = –90 dBm).
— Labels & Icons Opens a softkey menu to enable/disable
map data point labels and icon types.
Labels
OFF ON
Enables/Disables map data point labels. When
enabled, a label is displayed for every map data point
(e.g., “Data 1”). When disabled, labels are not
displayed for the map data points.
Icons
Flag Point Line
Sets the type of icon that is used to display a map’s
data points (default = Flag).