Keysight N9915-90020 User’s Guide 673
Noise Figure Mode (Option 356)
In this Chapter:
See Also
“Using Noise Figure” on page 674
“How to Define a Noise Figure Measurement” on page 680
— “Example: Typical Noise Figure Measurement Procedure”
on page 681
— “Overview of Softkey Menus” on page 682
— “How to Use DUT Measurement Setups” on page 690
— “Single / Continuous / Restart” on page 707
— “Points ” on page 707
— “Alignments” on page 708
— “Calculating Noise Figure Measurement Uncertainty” on
page 709
— “Using ENR Tables” on page 714
— “About ENR (*.enr), Preamplifier (*.amp), and DUT (*.dut)
Files” on page 715
— “Using Markers (Noise Figure)” on page 717
“Calibration Wizard” on page 718
“How to use Auto-Integration” on page 724
“Other Features Available” on page 730
“Troubleshooting” on page 731
“All about Markers” on page 734
“All about Limit Lines” on page 749
“All about Trace Math” on page 760
“All about Scale Settings” on page 762
Chapter 30, “Data Analysis Features.”
Chapter 33, “File Management.”
To Next Page
Loading...
