Keysight Technologies C Series - Page 780

776 Keysight N9915-90020 User’s Guide
System SettingsFUTURE
Utilities
To select a setting/value to edit, use the numeric
keypad, arrows, or rotary knob to change
the value.
Refer to
Figure 31-4 on page 779.
c. New to opens a corrections table of the currently
selected file (*.csv), but enables you to create a
new converter corrections file. Displays
"Overwrite existing Converter data?"
Then choose:
——
Yes to clear all of the frequency
converter correction table’s values and
enter your own.
——
No to leave the current correction table
values and edit just some of the entries.
To select a setting/value to edit, use the numeric
keypad, arrows, or rotary knob to change
the value.
Refer to
Figure 31-4 on page 779.
d.
Save Converter opens a ’labeler’ menu where
you can name and save your frequency converter
corrections file (*.csv) to the default
[INTERNAL]:\Converter folder.
e.
Recall Converter opens a menu where you can
recall a frequency converter corrections file
(*.csv).
Storage Device opens a menu where you can
change the storage location of your frequency
converter correction files (*csv). (Default =
Internal. Else press, SD Card or USB.)
See also,
Chapter 13, “Over–the–Air Measurements (OTA) – LTE FDD
Option 370, LTE TDD Option 371, 5G TF Option 377, 5G NR / 5G NR EVM
Conducted Option 378.”
It is important to save any changes that are made to the Settings table. If
the Setup Corr softkey is reset to Auto, it will recall the last
"...Default.csv" used, and any unsaved changes will be lost.