Keysight E4980A - Page 381

Keysight E4980A/AL Precision LCR Meter 381
SCPI Command Reference
Command list
List Sweep Limit value setup for the list sweep
measurement.
:LIST:BAND[1-201]
DC current list sweep setup :LIST:BIAS:CURRent
DC voltage list sweep setup :LIST:BIAS:VOLTage
List sweep setup clear :LIST:CLEar:ALL
AC current list sweep setup :LIST:CURRent
DC source list sweep setup :LIST:DCSource:VOLTage
Frequecy list sweep setup :LIST:FREQuency
Sweep mode selection for list sweep :LIST:MODE
Time stamp clear of the executed list
sweep
:LIST:SEQuence:TSTamp:CLEar
Time stamp readout of the list sweep :LIST:SEQuence:TSTamp:DATA
List sweep setup parameter :LIST:STIMulus:DATA
Actual stimulus values readout for
list sweep parameter
:LIST:STIMulus:MDATa
Parameter types selection for list
sweep parameter
:LIST:STIMulus:TYPE
AC voltage list sweep setup :LIST:VOLTage
Save/Recall State delete from the memories :MMEMory:DELete[:REGister]
State Load from the memories :MMEMory:LOAD:STATe[:REGister]
State Store to the memories :MMEMory:STORe:STATe[:REGister]
Status
register
Operation Status Condition register
readout
:STATus:OPERation:CONDition
Operation Status Enable register
setup
:STATus:OPERation:ENABle
Operation Status Event register
return
:STATus:OPERation[:EVENt]
Function Setting/execution item Command