Keysight E4980A - Page 402

402 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
Command list
10-
BIAS POL
AUTO Turns ON the Automatic Polarity Control :BIAS:POL:AUTO ON
FIX Turns OFF the Automatic Polarity Control :BIAS:POL:AUTO OFF
DC SRC Sets the voltage level of DC source :SOUR:DCS:VOLT:LEV
DCI ISO Sets the DC Isolation :OUTP:DC:ISOL:LEV:VAL
OFF Disables DC Isolation :OUTP:DC:ISOL:STAT OFF
ON Enables DC Isolation :OUTP:DC:ISOL:STAT ON
DCI RNG Selects DCI range :OUTP:DC:ISOL:LEV:VAL
AUTO Enables the auto range function for DCI :OUTP:DC:ISOL:LEV:AUTO
ON
HOLD Disables the auto range function for DCI :OUTP:DC:ISOL:LEV:AUTO
OFF
DCR RNG Selects DCR measurement range :FUNC:DCR:RANG:VAL
AUTO Enables the auto range function for the DCR
measurement
:FUNC:DCR:RANG:AUTO
ON
HOLD Disables the auto range function for the DCR
measurement
:FUNC:DCR:RANG:AUTO
OFF
DEV A
% Selects the deviation measurement mode :FUNC:DEV1:MODE PERC
ABS Selects the deviation measurement mode :FUNC:DEV1:MODE ABS
OFF Selects the deviation measurement mode :FUNC:DEV1:MODE OFF
DEV B
% Selects the deviation measurement mode :FUNC:DEV2:MODE PERC
ABS Selects the deviation measurement mode :FUNC:DEV2:MODE ABS
OFF Selects the deviation measurement mode :FUNC:DEV2:MODE OFF
FREQ Sets the measurement frequency :FREQ:CW
% Selects the deviation measurement mode :FUNC:DEV1:MODE PERC
ABS Selects the deviation measurement mode :FUNC:DEV1:MODE ABS
OFF Selects the deviation measurement mode :FUNC:DEV1:MODE OFF
FUNC
Key Operation Function SCPI Command