Krone MX 310 GL - Completion of the Loading Process; Preparations for the Unloading Process

Operation
156
Pos: 25.13 /BA/B edienung /L adewagen/Lade/E ntladevorgang/ Beenden des Ladevorgangs M edium/Ko mfort @ 2\mod_12 03580314361 _78.doc @ 66 735
11.6 Completion of the loading process
Note
Make sure that the permissible total weight specified on the type plate is not
exceeded.
The loading process is completed when:
a) for Medium :
• the red floor conveyor pilot lamp (with the floor conveyor being switched on) lights up.
b) for Comfort version:
• the display indicates "Full" and, at the same time, a brief horn sound is heard
After termination of the loading process, execute the functions one after the other:
• The conveyor unit must continue to operate.
• Raise the pick-up.
• Turn off the PTO.
• Turn off the hydraulics.
Pos: 25.14.1 /Üb erschriften/Üb erschriften 2/U-Z/ Vorbereiten d es Entlade vorgangs @ 0\m od_12011695 95747_78.doc @ 51479
11.7 Preparations for the Unloading Process
Pos: 25.14.2 /B A/Sicherheit/Lad ewagen/Befahr en von Fahrsil os @ 0\mo d_12011695312 16_78.doc @ 51 460
Danger!
Driving over silos
Effect: Danger to life, injuries or damage to the machine.
Steering axle must be locked while driving over.
No persons may remain in the danger zone.
Pos: 25.14.3 /B A/Bedienung /L adewagen/La de/Entladevorg ang/Vorbereit en des Entlade vorgangs Text @ 0\mod_119979 5425591_78.d oc @ 34977
• Before starting the unloading process, switch on the hydraulics on the tractor.
• Switch on the on-board electrical system.
• For Comfort version: The display for In-cab Comfort kit must be adjusted to the unloading
process. See Section "Unloading Process Basic Screen"
• Only extend the offset drawbar as far as necessary.
Pos: 25.14.4 /B A/Bedienung /L adewagen/La de/Entladevorg ang/Entladevorga ng Lenkachse sperren @ 0\mod_1201170 424935_78.d oc @ 51524
Note
The steering axle (special equipment) must be locked when driving over a
silo.
To do this, put pressure on the hydraulic connection prior to the crossover until the steered
wheels are in position for driving straight ahead. It may be necessary to drive straight forward or
backward a short distance. During the crossover, leave the pressure on the hydraulic
connection.
Pos: 25.14.5 /B A/-----Seitenu mbruch------ @ 0\mod_119617 5311226_0.doc @ 4165