Settings
169
Pos: 27.6.15 /Üb erschriften/Üb erschriften 3/K-O/M esser ein bauen @ 2\mod _12035878028 45_78.doc @ 66955
12.3.5 Inserting the cutters
Pos: 27.6.16 /B A/Sicherheit/Sc hneidwerk/Mess er einbau Lad ewagen @ 2\m od_120358 7872611_78.doc @ 66975
Warning!
Refitting of the cutters is not controlled
Effect: Damages to the machine
Ensure that:
• The cutters are positioned correctly on the bolt (1) at the pivotal point
and in safety rollers (2). To do so, the cutters must be cleaned in area
(3) to remove any solid dirt deposits that may adhere to the cutters.
• The safety rollers (2) turn with ease during the tensioning of the safety
levers with the multi-purpose key (4).
This will ensure that
• Only little effort is needed for switching with the multi-purpose key (4)
• The response threshold of the locking device for the individual blades
is working properly. (see chapter maintenance"Inspection of the safety
rollers on locking device for individual blades")
Pos: 27.6.17 /B A/Einstellungen/ Ladewagen/Sc hneidwerk/Mess er einbau Bild @ 2\mod_1 20358797128 3_78.doc @ 6 6994
KDW05145
2
1
3
Figure 111
Pos: 27.6.18 /B A/-----Seitenu mbruch------ @ 0\mod_119617 5311226_0.doc @ 4165
To Next Page
Loading...
