Krone MX 310 GL - Connecting the Trailer Hitch to the Trailer Coupling of the Tractor

Start-up
43
Pos: 14.11 /BA/I nbetriebnahm e/Ladewagen/A nkuppeln der A nhängeöse an die Schlepper- Anhängekuppl ung AX @ 3\ mod_120392270 2631_78.doc @ 68035
6.2.1 Connecting the trailer hitch to the trailer coupling of the tractor
1
AX000025
Figure 11
To make the connection, proceed as follows:
• Establish the electrical and hydraulic connections (refer to chapter "Hydraulics") and
place in operation.
• If necessary, adjust the hitching height according to the trailer coupling of the tractor
using the "Raise/lower offset drawbar" function at the electrical control box.
• Connect the trailer hitch.
• Raise the offset drawbar slightly to relieve the load on the support (1).
• Raise the support (1) and secure it in place.
Pos: 14.12 /BA/I nbetriebnahm e/Ladewagen/Hi nweis Anhänge öse nach DIN 11026! @ 0\ mod_1201012 059768_78.doc @ 49905
Note
Trailer hitch as per DIN 11026! The trailer may be coupled only to tractors with a suitable hitch
coupling (applies only to compressed air brake). For hitching height, refer to chapter
Commissioning "Changing the drawbar height and adjusting the hitch"
Pos: 14.13 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165