Safety
30
Pos: 10.20.14 / BA/Sicherheit/ Wartung/Wartung M äher mit G asspeicher+ Aus wechseln vo n Arbeitswerkze ugen @ 0\ mod_1195647075 607_78.doc @ 1442
4.12 Maintenance
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When carrying out maintenance work on a raised mowing unit, always use suitable
means to secure it against falling.
4 When replacing working tools with cutting edges, use suitable tools and gloves!
5 Oils, greases and filters must be disposed of correctly!
6 Always disconnect the power supply before working on the electrical system!
7 If protective devices and guards are subject to wear, check them regularly and replace
them in good time!
8 When performing electrical welding work on the vehicle and mounted devices, turn the
power supply off at main battery switch or disconnect generator cable and battery!
9 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
10 Only use nitrogen for filling pneumatic accumulators - risk of explosion!
Pos: 10.20.15 / BA/Sicherheit/Eig enmächtiger U mbau und Ers atzteilherstellu ng @ 1\mod_1 20193770553 9_78.doc @ 5 5745
4.13 Unauthorised Conversion/Modification and Spare Parts Production
Conversions or modifications of the machine are permitted only with prior consultation with the
manufacturer. Original spare parts and accessories authorised by the manufacturer help to
ensure safety. Use of other parts may void liability for resulting damage.
Pos: 10.20.16 / BA/Sicherheit/Un zulässige Betrie bsweisen @ 11\mod_1223 357699923_7 8.doc @ 1455 27
4.14 Inadmissible Modes of Operation
The operating safety of the delivered machine is guaranteed only when it is used as intended in
compliance with the introductory section "Intended use" of the operating instructions. The limit
values listed in the data charts should not be exceeded under any circumstances.
Pos: 10.20.17 / BA/Sicherheit/Sic herheitshinw eise an der Mas chine @ 1\mo d_120193786 1961_78.doc @ 55783
4.15 Safety Instructions on the Machine
The safety instructions on the machine warn of residual risks associated with the machine. They
consist of warning pictograms and a work safety symbol. All safety instructions must be
followed. Always keep the safety instructions clean and in clearly legible condition! If any safety
instructions are damaged or missing, request them from your dealer and then put them in the
places provided for them. Where these safety instructions are and what they mean will be
described in the following chapters.
Pos: 11 /BA/----- Seitenumbruch--- --- @ 0\mod _1196175311 226_0.doc @ 4165
To Next Page
Loading...
