Settings
168
Pos: 27.6.13 /B A/Einstellungen/ Ladewagen/Sc hneidwerk/Mess er schleifen @ 0\mod_119 9876628846_78. doc @ 36585
12.3.4 Grinding blades
Warning!
Grinding blades
Effect: Severe injuries to the eyes
• Always wear safety gloves and goggles when grinding the blades
KRS-1-062
Figure 110:
Check the sharpness of the blades (2) daily. If necessary, grind the blades after they have been
removed on the back of the cutting edge (1). Grind only the ungrooved side. When grinding,
make certain no notches are made in the area (3).
Note
• Less force is required during loading when the cutting blades are sharp
(this in turn lowers fuel consumption.
• If at all possible, use the KRONE grinding mechanism for grinding. The
Part No. for the blade holder for the KRONE blade grinding tool is 940
003-0.
• Avoid allowing the blades to heat up too much when grinding them. The
cutting blades are too hot if you can see discolouration in them.
Excessive heat reduces the service life of the cutting blades.
• The blades (2) must be checked before installation in area (3) (contact
point to the stop bar) for accumulations and thoroughly cleaned if
necessary. Otherwise it may no longer be possible to swivel the blade
bar in completely.
Pos: 27.6.14 /B A/-----Seitenu mbruch------ @ 0\mod_119617 5311226_0.doc @ 4165
To Next Page
Loading...
