Maintenance – lubrication chart
214
Pos: 31.52.1 /Üb erschriften/Üb erschriften 1/U-Z/ Wartung - Sc hmierplan @ 0 \mod_1197 359304198_78.doc @ 18232
14 Maintenance – lubrication chart
Pos: 31.52.2 /Üb erschriften/Üb erschriften 2/P-T /Spezielle Sich erheitshinweis e @ 0\mod_1 19666049576 0_78.doc @ 9 134
14.1 Special Safety Instructions
Pos: 31.52.3 /B A/Sicherheit/Ge fahrenhinweise /Ladewagen/ Gefahr Wartung allgemein @ 0\ mod_119988 4069862_78.doc @ 36704
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving.
Effect: Danger to life, injuries or damage to the machine.
• Switch off the tractor engine and remove the ignition key
• Secure the machine and tractor against the possibility of rolling back.
• Switch off the PTO and disengage it
• After the repair, maintenance and cleaning work or technical interventions are completed,
mount all protective coverings and safety devices properly again.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a
physician immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 31.52.4 /B A/Wartung/La dewagen/Schmi erung Allgemein @ 0\mod_1 200042088341_ 78.doc @ 3 9010
The information on maintenance intervals is based on average load of the machine. If the load
is heavier or under extreme working conditions, the time periods must be reduced.
Definition of terms:
Terms Lubricant Location/quantity Special features
Grease Multi-purpose grease Lubrication points/about two
strokes from grease gun.
Remove superfluous grease
at the lubrication point.
Lubrication Unless otherwise
recommended, use
vegetable oils
Sliding surface/apply thin
with a brush.
Remove old and superfluous
oil
Oils Unless otherwise
recommended, use
vegetable oils
Chains Distribute evenly on chain
Pos: 31.52.5 /B A/-----Seitenu mbruch------ @ 0\mod_119617 5311226_0.doc @ 4165