EasyManua.ls Logo

Krone MX 310 GL - Hydraulics; Special Safety Instructions

Krone MX 310 GL
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Start-up
44
Pos: 14.14 /Üb erschriften/Üb erschriften 2/F-J/H ydraulik @ 0\ mod_119977 6034950_78.doc @ 34205
6.3 Hydraulics
Pos: 14.15 /Üb erschriften/Üb erschriften 3/P-T/S pezielle Sich erheitshinweis e @ 0\mod_119 7301069931_ 78.doc @ 1766 2
6.3.1 Special Safety Instructions
Pos: 14.16 /BA/Sic herheit/Hydra ulik/Anschluss der Hydrauli kleitungen @ 0 \mod_11997765 48685_78.doc @ 34225
Warning ! - Connection of the hydraulic line
Effect: severe injuries due to penetration of hydraulic oil under the skin.
When connecting the hydraulic hoses to the hydraulic system of the tractor, the system
must be relieved of the pressure on either side.
Due to the risk of injury when searching for leaks, always use suitable tools and wear
protective goggles.
Seek medical help immediately should injuries occur! Danger of infection.
Depressurise prior to uncoupling the hydraulic hoses and working on the hydraulic
system!
Check the hydraulic hose lines at regular intervals and replace them if damaged or worn!
The replacement hoses must fulfil the technical requirements set by the equipment
manufacturer.
Pos: 14.17 /BA/I nbetriebnahm e/Schwader/Hin weis Hydrauli kaufkleber beac hten @ 9\ mod_121999753178 5_78.doc @ 1 24879
Note
Connect the hydraulic lines correctly
The hydraulic hoses are identified by coloured hose clips.
When connecting the hydraulic lines, observe the sticker for the tractor hydraulics (see
the "Safety" chapter: "Position of the general information labels on the machine").
Pos: 14.18 /BA/ Wartung/Load- Sensing/SW 100 0/Hinweis L oad-Sensing @ 0\mod_11997 80169747_78.do c @ 34427
Note
With closed (constant pressure or load-sensing) hydraulic system and connected load-
sensing line:
Before coupling, screw in the system screw (1) on the hydraulic block fully.
With open (constant-current) hydraulic system and not connected load-sensing pipe:
The system screw (1) is preset in the factory. (The system screw (1) on the hydraulic block
must be screwed in up to the stop.)
Pos: 14.19 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165

Table of Contents

Related product manuals