Krone MX 310 GL - Switching off the Floor Conveyor (GD)

Maintenance
198
Pos: 31.25 /Üb erschriften/Üb erschriften 2/A-E/ Abschaltung d es Kratzbodens ( GD) @ 1\mo d_120125036 0479_78.doc @ 52482
13.20 Switching off the Floor Conveyor (GD)
Pos: 31.26 /BA/ Wartung/Ladew agen/Abschalt ung des Kratzb odens Bild AX ( GD) @ 3\mod _1203601649 283_78.doc @ 6 7353
1
AX000013
50h
2
Figure 130:
Pos: 31.27 /BA/ Wartung/Ladew agen/Abschalt ung des Kratzb odens (GD) @ 0\mod_119 9967309756_78.d oc @ 37837
The right bearing of the lower discharge roller is movably mounted. The motion sensor (1) is
located on the bottom of the bearing. It records the offset of the discharge roller.
Movement of the support
The switch-off movement of the sensor is determined by a tension spring (2).
• Tighten tension spring (2) = longer switch-off delay = more force acting on the discharge
rollers
• Loosen tension spring (2) = shorter switch-off delay = less force acting on the discharge
rollers
Note
Free movement of the bearing must be ensured. It must therefore be regularly
lubricated with a grease gun, in any case at least every 50 operating hours.
Pos: 31.28 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165