Krone MX 310 GL - After Unloading (GL+GD); After Travelling over a Silo (GL+GD)

Operation
158
Pos: 25.14.17 / BA/Bedienung / Ladewagen/Kra tzboden/Kratzb odenrücklauf ( nur bei GD-Au sführung) AX @ 2\mod_12035 80627236_78. doc @ 66775
Floor conveyor reverse (GD design only)
Caution!
Overload of the floor conveyor
Effect: Material Damages
• Activate the reverse of the floor conveyor only for a brief period in order
to prevent an overload of the floor conveyor.
Should the discharge rollers get stuck, switch on the reverse of the floor conveyor.
To do this:
• Briefly activate the control unit on the tractor for the hydraulic system in the opposite
direction. The floor conveyor reverse is activated.
• Then, pressurise the hydraulic system via the control unit on the tractor.
Pos: 25.14.18 / BA/Bedienung / Ladewagen/L ade/Entladevorga ng/Nach de m Entladen (GL+ GD) @ 0\mo d_119979985 5200_78.doc @ 35224
11.9 After unloading (GL+GD)
• Switch off the floor conveyor. (GL+GD)
• Switch off the PTO shaft (GD design only)
Pos: 25.14.19 / BA/Sicherheit/G efahrenhin weise/Ladewagen/Sc halten der Z apfwelle @ 0\m od_119979783 0763_78.doc @ 35091
Caution!
Switching of the PTO shaft
Effect: Material Damages
Switching of the PTO shaft during the unloading process only when operating
on idle and the tailgate is open.
Pos: 25.14.20 / BA/Bedienung / Ladewagen/Hec klappe/Hin weis Heckklappe schließen GD @ 0\mod_11 99800008810_7 8.doc @ 3524 3
Note
By closing the tailgate, the discharge rollers are switched off automatically.
Pos: 25.14.21 / BA/Bedienung / Ladewagen/Hec klappe/Hec kklappe schließe n. (GL+GD) @ 0\mod_11998 00112341_78.d oc @ 35263
• Closing the tailgate. (GL+GD)
Pos: 25.14.22 / BA/Bedienung / Ladewagen/L ade/Entladevorga ng/Nach de m Überfahren ein es Fahrsilos ( GL+GD) @ 0\m od_119980018 5997_78.doc @ 35282
11.9.1 After travelling over a silo (GL+GD)
• lower the offset drawbar back down.
Pos: 25.15 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165