Medium Control Unit
72
Pos: 19.40 /BA/I nfo-Center/La dewagen/Mediu m/Meldungen @ 28\mod_12 49983982520_7 8.doc @ 27301 5
8.17 Messages
8.17.1 Wagon full
(L/GL design only)
Note
If the wagon is full and the key (11) floor conveyor speed activated, a constant
horn signal will sound for at least one second.
(D/GD design only)
Note
If the wagon is full and the key (12)
floor conveyor speed activated, a
constant horn signal will sound for at least one second.
8.17.2 Cutters removed
Note
If the cutters swivel out of the retracted position (working position), a horn signal will sound for
two seconds (high frequency).
Pos: 19.41 /BA/I nfo-Center/Sch wader/Bedien einheit - Mediu m/Swadro 10 00/Alarmmeldu ngen @ 2\mod_ 120332471315 2_78.doc @ 6 5631
8.18 Alarm Messages
If a fault occurs in the machine's electronics, it will be displayed by an appropriate flashing
signal of the LED on the
key. The buzzer also sounds the same error code for 5 cycles.
Pos: 19.42 /BA/I nfo-Center/Sch wader/Bedien einheit - Mediu m/Swadro 10 00/Beispiel Sens orfehler @ 2\ mod_120332486 6121_78.doc @ 65650
Example: Sensor error (11) (Error code "21")
0 1 2 3 4 5
1
0
t6 7
2 1 2 1= 21" = 21"
SW1000033
Figure 37:
Temporal sequence:
Pulse duration 200 ms, pulse pause 200 ms, pause between two signal sequences 2 s, pause
between the numbers of a signal sequence 800 ms.
Pos: 19.43 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165
To Next Page
Loading...
