Malfunctions - Causes and Remedies
228
Pos: 35.1 /Übersc hriften/Übersc hriften 1/P-T/ Störungen - Urs achen und Beh ebung @ 0\m od_1200296925 180_78.doc @ 39459
17 Malfunctions - Causes and Remedies
Pos: 35.2 /Übersc hriften/Übersc hriften 2/P-T/ Spezielle Sic herheitshinweise @ 0\mod_1196 660495760_7 8.doc @ 9134
17.1 Special Safety Instructions
Pos: 35.3 /BA/Sich erheit/Gefahr enhinweise/La dewagen/G efahr Wartung allg emein @ 0\ mod_119988406 9862_78.doc @ 36704
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving.
Effect: Danger to life, injuries or damage to the machine.
• Switch off the tractor engine and remove the ignition key
• Secure the machine and tractor against the possibility of rolling back.
• Switch off the PTO and disengage it
• After the repair, maintenance and cleaning work or technical interventions are completed,
mount all protective coverings and safety devices properly again.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a
physician immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 35.4 /BA/St örungen - Urs achen und Beh ebung/Ladew agen/Tabellarisc he Auflistung L adewagen @ 36\mod_1258 716401209_78.d oc @ 335661
Malfunction
Possible cause
Remedy
Blockages in the feed area Swaths are of uneven height or
too large
Pick up smaller, more uniform
swaths
Stop immediately and
switch off the P.T.O.
shaft!
Travelling speed too high Reduce travelling speed
Roller crop guide of Pick-up too
low
Position roller crop guide higher
Passage in feed channel is too
small
Observe hitching height
The overload coupling engages
during loading
Always switch off the P.T.O. shaft Determine the cause for the fault
and eliminate it. Then turn the P.T.O. shaft on again
Travelling speed too high Reduce travelling speed
Blade dull Remove dull blades and sharpen
them or replace them with new
ones
Material loaded in the upper
channel is being baled with too
much pressing force
Do not switch on feed too late
Noises can be heard from the
conveyor drum
Blade(s) defective Replace defective blade(s)
Scrapers are not in alignment Replace or straighten the
scrapers
Tines of the conveyor drum bent Straighten tines
To Next Page
Loading...
